blob: 6feaeb4b1f41f03c3862eeef3f794fa25b5f66a5 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
|
NETCTL-AUTO(1)
==============
NAME
----
netctl-auto - Control automatic selection of wireless netctl profiles
SYNOPSIS
--------
*netctl-auto* {*COMMAND*} ...
*netctl-auto* [--help | --version]
DESCRIPTION
-----------
*netctl-auto* may be used to control the automatic network profile
selection offered by the 'netctl-auto@.service' file. See
*netctl.special*(7) for details about the service file.
OPTIONS
-------
The following commands are understood:
*list*::
List all profiles which are currently available for automatic
selection. Active profiles will be marked with a `*', disabled
profiles will be marked with a `!'.
*current*::
Report currently active profiles.
*switch-to [+PROFILE+]*::
Switch to the network profile specified on the command line. The
specified profile will be enabled if necessary, the state of all
other profiles is not changed. This command does not force
*netctl-auto* to use the specified profile. If a disconnect occurs,
*netctl-auto* may select an alternative profile.
*enable [+PROFILE+]*::
Enable a previously disabled network profile for automatic
selection. Every time the *netctl-auto* service is started, all
available profiles are enabled by default.
*disable [+PROFILE+]*::
Disable the specified profile for automatic selection. This will
only take effect until the *netctl-auto* service is stopped. To
permanently exclude a profile from automatic selection, use the
'ExcludeAuto=yes' option in the profile.
*enable-all*::
Enable all profiles for automatic selection.
*disable-all*::
Disable all profiles for automatic selection.
*start [+INTERFACE+]*::
Start automatic profile selection on the specified interface. +
This command should not be invoked directly, use the following
command instead:
-----------------------------------------------
systemctl start netctl-auto@<interface>
-----------------------------------------------
*stop [+INTERFACE+]*::
Stop automatic profile selection on the specified interface. This
will disconnect the currently active profile on the interface. +
This command should not be invoked directly, use the following
command instead:
----------------------------------------------
systemctl stop netctl-auto@<interface>
----------------------------------------------
EXIT STATUS
-----------
On success 0 is returned, a non-zero failure code otherwise.
ENVIRONMENT
-----------
'$NETCTL_DEBUG'::
If set to +"yes"+, debugging output is generated.
SEE ALSO
--------
*netctl*(1), *netctl.profile*(5), *netctl.special*(7)
|
