From f5f7dfa0647bac09c60cbf0247d46f3fedb43a9c Mon Sep 17 00:00:00 2001 From: Jack Humbert Date: Wed, 28 Jun 2017 00:26:05 -0400 Subject: cleanup lets_split --- keyboards/lets_split/readme.md | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) (limited to 'keyboards/lets_split/readme.md') diff --git a/keyboards/lets_split/readme.md b/keyboards/lets_split/readme.md index d665d013e..610b776ee 100644 --- a/keyboards/lets_split/readme.md +++ b/keyboards/lets_split/readme.md @@ -19,14 +19,13 @@ There is additional information there about flashing and adding RGB underglow. Download or clone the whole firmware and navigate to the keyboards/lets_split directory. Once your dev env is setup, you'll be able to generate the default .hex using: ``` -$ make rev2 +$ make rev2-default ``` -You will see a lot of output and if everything worked correctly you will see the built hex files: +You will see a lot of output and if everything worked correctly you will see the built hex file: ``` -lets_split_rev2_serial.hex -lets_split_rev2_i2c.hex +lets_split_rev2_default.hex ``` If you would like to use one of the alternative keymaps, or create your own, copy one of the existing [keymaps](keymaps/) and run make like so: @@ -101,6 +100,8 @@ The pull-up resistors may be placed on either half. It is also possible to use 4 resistors and have the pull-ups in both halves, but this is unnecessary in simple use cases. +You can change your configuration between serial and i2c by modifying your `config.h` file. + Notes on Software Configuration ------------------------------- @@ -115,7 +116,7 @@ not be very difficult to adapt it to support more if required. Flashing ------- From the keymap directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing. -Example: `make rev2-serial-avrdude` +Example: `make rev2-default-avrdude` Choosing which board to plug the USB cable into (choosing Master) -- cgit v1.2.3-24-g4f1b