From 39ece819791eed7f57e0a0492c1aa774be5c4b24 Mon Sep 17 00:00:00 2001 From: Jack Humbert Date: Fri, 7 Jul 2017 11:56:01 -0400 Subject: delete old lufa --- .../LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt | 30 ---------------------- 1 file changed, 30 deletions(-) delete mode 100644 tmk_core/protocol/lufa/LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt (limited to 'tmk_core/protocol/lufa/LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt') diff --git a/tmk_core/protocol/lufa/LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt b/tmk_core/protocol/lufa/LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt deleted file mode 100644 index 4759ac87a..000000000 --- a/tmk_core/protocol/lufa/LUFA-git/LUFA/DoxygenPages/ProgrammingApps.txt +++ /dev/null @@ -1,30 +0,0 @@ -/** \file - * - * This file contains special DoxyGen information for the generation of the main page and other special - * documentation pages. It is not a project source file. - */ - -/** \page Page_ProgrammingApps Programming an Application into a USB AVR - * - * Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your - * application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the - * reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the - * supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer, - * a third party programmer, or an official Atmel AVR tool - for more information, see the atmel.com website. - * - * Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel - * DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the - * AVR to be programmed through a non-standard interface such as the serial USART port, SPI, or (in this case) USB. - * Bootloaders have the advantage of not requiring any special hardware for programming, and cannot usually be erased - * or broken without an external programming device. They have disadvantages however; they cannot change the fuses of - * the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the - * AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the - * loaded application. - * - * If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation. - * Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible) - * alternative exists called "dfu-programmer". - * - * \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader - * programming makefile targets. - */ -- cgit v1.2.3-24-g4f1b