# MCU name
MCU = atmega32u4


# Processor frequency.
#     This will define a symbol, F_CPU, in all source code files equal to the
#     processor frequency in Hz. You can then use this symbol in your source code to
#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
#     automatically to create a 32-bit value in your source code.
#
#     This will be an integer division of F_USB below, as it is sourced by
#     F_USB after it has run through any CPU prescalers. Note that this value
#     does not *change* the processor frequency - it should merely be updated to
#     reflect the processor speed set externally so that the code can use accurate
#     software delays.
F_CPU = 16000000


# LUFA specific
# Target architecture (see library "Board Types" documentation).
ARCH = AVR8


# Input clock frequency.
#     This will define a symbol, F_USB, in all source code files equal to the
#     input clock frequency (before any prescaling is performed) in Hz. This value may
#     differ from F_CPU if prescaling is used on the latter, and is required as the
#     raw input clock is fed directly to the PLL sections of the AVR for high speed
#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
#     at the end, this will be done automatically to create a 32-bit value in your
#     source code.
#
#     If no clock division is performed on the input clock inside the AVR (via the
#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
F_USB = $(F_CPU)


# Interrupt driven control endpoint task(+60)
OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT


# Boot Section Size in *bytes*
#   Teensy halfKay   512
#   Teensy++ halfKay 1024
#   Atmel DFU loader 4096
#   LUFA bootloader  4096
#   USBaspLoader     2048
OPT_DEFS += -DBOOTLOADER_SIZE=4096


# Build Options
AUDIO_ENABLE = no           # Audio output on port C6
BACKLIGHT_ENABLE = yes      # Enable keyboard backlight functionality
BLUETOOTH_ENABLE = no       # Enable Bluetooth with the Adafruit EZ-Key HID
BOOTMAGIC_ENABLE = yes      # Virtual DIP switch configuration(+1000)
COMMAND_ENABLE = no         # Commands for debug and configuration
CONSOLE_ENABLE = no         # Console for debug(+400)
EXTRAKEY_ENABLE = yes       # Audio control and System control(+450)
MIDI_ENABLE = no            # MIDI controls
MOUSEKEY_ENABLE = yes       # Mouse keys(+4700)
NKRO_ENABLE = yes           # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
RGBLIGHT_ENABLE = yes       # Enable WS2812 RGB underlight. 
SLEEP_LED_ENABLE = no       # Breathing sleep LED during USB suspend
UNICODE_ENABLE = no         # Unicode

LAYOUTS = 60_ansi