blob: d2083ac17e39243f2f80e5b23438036853f93c6a (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
|
NETCTL-AUTO(1)
==============
NAME
----
netctl-auto - Control automatic selection of wireless netctl profiles
SYNOPSIS
--------
*netctl-auto* {*COMMAND*} ...
*netctl-auto* [--help | --version]
DESCRIPTION
-----------
*netctl-auto* may be used to control the automatic network profile selection
offered by the 'netctl-auto@.service' file. See *netctl.special*(7) for
details about the service file.
OPTIONS
-------
The following commands are understood:
*list*::
List all profiles which are currently available for automatic selection.
Active profiles will be marked with a '*', disabled profiles will be
marked with a '!'.
*current*::
Report currently active profiles.
*switch-to [+PROFILE+]*::
Switch to the network profile specified on the command line. The
specified profile will be enabled if necessary, the state of all other
profiles is not changed. This command does not force *netctl-auto* to use
the specified profile. If a disconnect occurs, *netctl-auto* may select
an alternative profile.
*enable [+PROFILE+]*::
Enable a previously disabled network profile for automatic selection.
Every time the *netctl-auto* service is started, all available profiles
are enabled by default.
*disable [+PROFILE+]*::
Disable the specified profile for automatic selection. This will only
take effect until the *netctl-auto* service is stopped.
To permanently exclude a profile from automatic selection, use the
'ExcludeAuto=yes' option in the profile.
*enable-all*::
Enable all profiles for automatic selection.
*disable-all*::
Disable all profiles for automatic selection.
*start [+INTERFACE+]*::
Start automatic profile selection on the specified interface. +
This command should not be invoked directly, use the following command
instead:
---------------------------------------------
systemctl start netctl-auto@<interface>
---------------------------------------------
*stop [+INTERFACE+]*::
Stop automatic profile selection on the specified interface. This will
disconnect the currently active profile on the interface. +
This command should not be invoked directly, use the following command
instead:
--------------------------------------------
systemctl stop netctl-auto@<interface>
--------------------------------------------
EXIT STATUS
-----------
On success 0 is returned, a non-zero failure code otherwise.
ENVIRONMENT
-----------
'$NETCTL_DEBUG'::
If set to +"yes"+, debugging output is generated.
SEE ALSO
--------
*netctl*(1), *netctl.profile*(5), *netctl.special*(7), *systemctl*(1)
|
